Simrad Rf300 Installation Manual ((free)) -

If the autopilot displays a "Rudder Feedback Failure" alarm, or steers erratically, check the following:

The Simrad RF300 connects to your autopilot computer via a CAN (Controller Area Network) bus, making integration straightforward for modern marine electronics systems. The RF300 is compatible with a wide range of Simrad autopilot computers, including the NAC-3, AC42, AC12, AD80, and many others.

Before securing the unit, rotate the transmitter lever until the alignment marks are perfectly centered. These marks should be opposite the cable entry point of the feedback unit. Tiller Arm Connection:

Position the unit close to the rudder tiller arm to keep the transmission link short. simrad rf300 installation manual

Careful alignment is necessary during installation. Improper installation can result in constant rudder feedback alarms. 2. Preparing for Installation

Proper mechanical installation is critical for accurate steering.

The Simrad RF300 is a rugged, high-performance remote control for compatible Simrad multifunction displays (MFDs) and autopilot systems. This manual covers mechanical installation, wiring, initial setup, and important safety information. If the autopilot displays a "Rudder Feedback Failure"

Here is the text in a clear, structured format suitable for inclusion in a technical document or manual.

Inspect the ball joints on the linkage rod. Lubricate them with a high-quality, water-resistant marine grease.

What specific are you installing this on? These marks should be opposite the cable entry

Choose a dry, accessible location above the normal bilge water level. Ensure the moving arms have total clearance throughout the full rudder sweep. 3. Mechanical Installation Steps

When the rudder is at 0°, both the rudder tiller arm and the RF300 arm must sit at exactly 90 degrees relative to the transmission link rod.