V21 Manual Link: Makerbase Mks Dlc

Insert your stepper drivers into the slots for the X, Y, and Z axes.

The board includes dedicated ports for X, Y, and Z limit switches.

The primary official resource for this board is the MKS DLC GitHub Repository, which contains the schematics, pinouts, and hardware specifications. MKS DLC v2.1 Key Manual Resources

The Makerbase MKS DLC v2.1 stands as a cornerstone for DIY CNC and laser engraving enthusiasts, bridging the gap between digital instructions and physical creation. Based on the robust ATmega328P microcontroller—the same heart found in the Arduino Uno—this board is optimized for the GRBL firmware, a high-performance, open-source standard for controlling motion.

The DLC v2.1 is an "all-in-one" board designed to run GRBL. It supports 3-axis control (X, Y, and Z) and features specific ports for laser TTL control and CNC spindles. Key Specifications ATMega328P (8-bit) Input Voltage: 12V to 24V DC Supported Drivers: A4988, DRV8825, TMC2208, TMC2209 Interface: USB for PC connection 🔌 Setup and Wiring Guide makerbase mks dlc v21 manual link

The MakerBase MKS DLC V21 is a highly advanced 3D printer controller designed to work with a wide range of 3D printing setups. This device is capable of controlling everything from the movement of the print head to the temperature of the hotend and bed, making it an essential component of any 3D printing system. With its user-friendly interface and robust feature set, the MKS DLC V21 is an ideal solution for both beginners and experienced 3D printing enthusiasts.

Proper wiring is essential to prevent damage to the board or laser module. The V2.1 board is clearly labeled, but special attention should be paid to the laser and motor connections. Motor Connections

– usually found under /Hardware or /Documentation . Check: https://github.com/makerbase-mks/MKS-DLC32/tree/master/Hardware

Use XLoader to upload the .hex firmware file. Set the baud rate to 115200 or 57600 depending on the specific GRBL version. Insert your stepper drivers into the slots for

: Instructions for flashing GRBL firmware and configuring the board for your specific machine. Key Technical Specifications Processor: High-speed 32-bit ESP32-WROOM-32U module. Input Power: Supports DC 12V–24V.

General wiring instructions for the DLC series can be found on sites like Solo Motor Controllers (Note: While this manual focuses on the DLC32, many basic wiring principles for motors and endstops are shared). Technical Specifications Specification Microprocessor ATMEGA328P (8-bit) Input Power DC 12V / 24V (supports 10A fuse) Compatible Firmware GRBL 1.1h or later Axes Supported 3-Axis (X, Y1, Y2, Z) Interface Support USB (CH340 chip), MKS TFT Series displays Connectivity Offline engraving with TF card (supported on some models) Hardware Connection Overview How to Connect a Display and Stepper Motor to MKS-DLC32

Once the hardware is installed, it's time to configure the software. This includes:

Connects to a standard 3D printer-style power supply. Ensure polarity is correct (V+ and GND). MKS DLC v2

: Detailed PDF schematics and board layout images to help with connection setups.

Insert all 3 jumpers for maximum 1/32 microstepping. 3. Motor Outputs

The MKS DLC V2.1 is a high-performance, 32-bit controller board designed for desktop engraving machines and CNCs. Its hardware is built around a powerful ESP32-WROOM-32U module, an upgrade from the 8-bit CPUs of older models.